Alargador VGA usando cable de red CAT5

Escrito por telemaco3 en . Escrito en Todo Hardware

Valoración del Usuario:  / 1
MaloBueno 

EL TEXTO FUENTE

 

VGA over Cat-5 ethernet cable

It's possible to send a VGA "video" signal down an ordinary Cat-5 ethernet cable. This is possible for two reasons: firstly, although VGA connectors have 15 (or 13) pins, only about 8 wires are actually necessary to send the VGA signal; and secondly, ethernet cable is twisted pair, and we can use the magic of twisted pair to push the analog VGA signal further than spec.

The diagram above shows conversion from HD15 (VGA) to RJ45 (an ethernet socket). A similar adapter is used to convert back again. Connectors are shown from the solder side. This diagram assumes your Cat-5 cable is crimped in the standard way (not as a cross-over cable).

This is nifty because:

  • Cat-5 is cheaper than a VGA cable (whether you're buying pre-made Ethernet cables or crimping your own off a roll),
  • you can run Cat-5 easily through conduits,
  • electricians understand what Cat-5 is and how they should run it,
  • you may already have Cat-5 in your walls
  • compared to other VGA-over-something solutions, it's cheap, compact, and does not require its own power

Standard VGA extension cables come in lengths of 1.8 metres (6 feet), and if you need to go a bit further you can daisy-chain several of these, with a little signal loss. You can also get a super-special low-loss 30 metre (100 foot) VGA extension cable, but they're very expensive and very hard to find. Additionally, their fat VGA plug ends won't run through conduit smaller than about 50mm.

I've run VGA over Cat-5 for distances of about 15 metres (50 feet). At this range, the 800x600 screen looked fine when it was displaying a coloured background; although when it was displaying black, a lighter gray region was visible, probably due to interference from the synch signals. Your mileage will vary depending on screen res and refresh rate (lower will go further), contrast and brightness in the image (high contrast and brightness will go further), and interference from other sources (running the cable in its own metal conduit is best; if you're not in conduit, running parallel to other cables is bad).

This trick will work equally well with Cat-5e and Cat-6; possibly even a little better.

There are two easy ways to implement the above diagram:

  • Etch circuit boards,
  • Use an RJ45-to-DB9 adapter, but replace the DB9 with an HD15.

Etch circuit boards

Above is artwork for two adapters, on single-sided PCB. On the right is a male HD15 to RJ45, to plug into the back of your computer. There are three "components" on the board: the HD15 connector, the RJ45 connector, and a wire link.

For the monitor end, you can use the board on the left, which has an RJ45, a female HD15, and five wire links. Or you can simply use two of the male HD15-to-RJ45, plus a female-female VGA gender changer.

Print at 300 dpi. The artwork is shown here from the component side -- print it onto transparency film, and then flip the transparency over so that the text runs the correct way. There are nice wide tracks with wide gaps between to allow easy etching; and nice big solder pads to allow easy drilling and soldering. The very thin "solder pads" are merely drill guides.

Documento realizado por Manuel (telemaco3) para TodoHTPC.

Junio 2006

Nuestro Twitter